Refractory Balls & Heat Storage Media

A refractory ball bed is a heat exchanger made of spheres: it absorbs heat from a hot gas, then gives it back to the cold stream on the reverse cycle. The media must survive that reversal thousands of times without spalling, and must not soften under the load of the bed above it. This is a materials problem more than a shape problem.

Specifications

ParameterDetail
FormSolid spheres, refractory body
DutyHeat storage and recovery beds, hot gas distribution, refractory packing
Key selection inputsPeak temperature, cycle frequency, thermal gradient, bed depth and load
Critical propertiesRefractoriness under load, thermal shock resistance, low spalling
Related gradesHigh alumina for load bearing, porous for surface area duty

Available Materials

High alumina refractory · Mullite · Chamotte / fireclay based bodies

Typical Applications

  • Hot blast stoves and regenerative heat exchangers
  • RTO and thermal oxidiser heat exchange beds
  • High temperature gas distribution layers
  • Refractory linings and vessel protection layers
  • Kiln and furnace packing

How the Options Compare

Refractory media are chosen for temperature and cycling, not for mass transfer. Compared with a structured heat exchange block they are cheaper and easier to replace in sections, but they carry more pressure drop and occupy more volume for the same heat transfer.

Frequently Asked Questions

How do I choose between refractory and high alumina balls?

Both are refractory bodies; the difference is where the emphasis sits. Heat storage duty stresses thermal shock resistance, while deep beds stress refractoriness under load. Send the temperature profile and cycle and we will match the body.

Can the bed be replaced in sections?

Yes. Beds are normally removed and reloaded in layers, and we can supply replacement media without disturbing the supporting structure if it is still sound.

Do you provide support layers for these beds?

Yes — graded support media and support plates are supplied together with the working bed so the load path is designed as one system.

More Ceramic Balls

Inert Alumina Ceramic Ball

Inert alumina ceramic balls for catalyst bed support, hold-down and flow distribution in reactors, columns and…

High Alumina Ball

High alumina balls for heavy catalyst beds, high temperature reactors and refractory duty. Higher crush streng…

Porous Ceramic Ball

Porous ceramic balls with open structure for gas filtration, flow distribution and as a catalyst carrier base.…

Ask about refractory ball

Tell us your flow rate, medium and operating conditions — we recommend the right packing and internals, and quote factory-direct.

Request a Quote WhatsApp