Activated Alumina & Molecular Sieves

Adsorbents do the part of gas treating that absorption and distillation cannot: pulling water, CO2, sulphur compounds or fluoride down to parts-per-million levels, then giving them up again on regeneration so the bed can be used for years.

Activated Alumina

Activated alumina balls for gas and liquid drying, fluoride removal, hydrogen peroxide purification and Claus ca…

Molecular Sieve 3A

3A molecular sieve (potassium form) for drying cracked gas, olefins and ethanol where CO2 and heavier components…

Molecular Sieve 4A

4A molecular sieve (sodium form) for gas and liquid drying, CO2 and H2S removal, refrigerant drying and static d…

Molecular Sieve 5A

5A molecular sieve (calcium form) for PSA oxygen generation, n-paraffin separation and combined drying with CO2 …

Molecular Sieve 13X

13X molecular sieve (sodium X type) for air prepurification, bulk CO2 and water removal, mercaptan and THT remov…

Two families cover most of this duty. Activated alumina is the workhorse desiccant and fluoride-removal medium — cheap, mechanically strong, and tolerant of the cycling that bed regeneration imposes. Molecular sieves are zeolites with a defined pore opening, which lets you dry a stream without also adsorbing the components you want to keep.

Choosing between them is mostly about selectivity and regeneration. If you only need water out and nothing else matters, activated alumina is usually enough. If the same bed must also remove CO2, or if the stream contains components that would be damaged by co-adsorption, a sieve with the right pore opening is the only answer.

We supply both, and we size the bed against your inlet condition, target dew point and cycle time rather than quoting a catalogue grade.

Related to adsorbents

Ask about adsorbents & desiccants

Tell us your flow rate, medium and operating conditions — we recommend the right packing and internals, and quote factory-direct.

Request a Quote WhatsApp