Types & Configurations
Bar grid support
Parallel or crossed bars on a support ring. High open area, low pressure drop and good liquid drainage — the usual choice under random packing where the bed load is moderate.
Perforated / corrugated support plate
A plate with punched or slotted openings, often corrugated for stiffness. Gives a more uniform support surface and higher load capacity than a simple grid, at some cost in open area.
Gas-injection support plate
A support with dedicated gas passages, used where the gas rate is high enough that a plain grid would create a pressure-drop penalty or where two-phase flow enters at the bottom of the bed.
Ceramic support and brick courses
For ceramic packing in corrosive service, or where the bed sits on a refractory-lined vessel. Supplied as support rings, grids or a graded brick/ball layer.
Specifications
| Parameter | Detail |
|---|---|
| Type | Bar grid, perforated plate, corrugated plate, gas-injection, ceramic |
| Opening size | Set smaller than the nominal packing size you are using |
| Materials | SS304, SS316L, carbon steel (coated), duplex, PP, PVDF, ceramic |
| Support ring | Welded to vessel or supplied loose with clamping detail |
| Segmentation | Split into manway-sized sections with bolted or hooked joints |
| Load basis | Sized against your bed weight, liquid holdup and fouling allowance |
| Access | Removable panels for bed change-out and cleaning |
Available Materials
SS304 · SS316L · Carbon steel · Duplex stainless steel · PP · PVDF · Ceramic
Typical Applications
- Random packing beds in distillation and absorption columns
- Structured packing beds with collector above
- Scrubbers and packed towers
- Ceramic packing in acid and chlorine service
- Columns with periodic bed washing or replacement
Selection & Design Notes
- Openings must be smaller than the smallest packing piece in the bed. If you are changing packing size, tell us — the plate may need to change with it.
- The load case is not just dry packing weight. Add liquid holdup in operation and a fouling allowance if the service is dirty; undersized plates deflect, and a deflected bed channels.
- Open area trades against strength. We size the bars and beams for your load and then check the resulting pressure drop against your process allowance.
- Plan for access. A support plate that cannot be removed through the manway turns a bed change-out into a vessel entry job.
- In corrosive service, specify the material rather than relying on coating — coated carbon steel fails at every cut edge and weld.
How the Options Compare
A bar grid is the cheapest way to support a moderate bed with minimum pressure drop. A perforated or corrugated plate costs more but carries heavier beds and gives a flatter support surface. Gas-injection designs are used where pressure drop at the bed inlet actually matters to the process; ceramic supports are chosen for chemical compatibility, not for strength.